Hardware die casting factory to check the appearance of the condition?
Date:
2019-12-31
Hardware die casting factory to popularize the environmental conditions on the appearance of hardware die casting inspection. Metal die casting plant is a method of casting liquid die forging. This process is completed in a special die casting die forging machine, but there is a basic process flow. After the hardware die casting factory is made, it is necessary to check and accept it, and the inspection and acceptance need to be carried out under the environmental conditions that can be used.

The hardware die casting factory came to popularize the environmental conditions for the appearance inspection of hardware die castings. Hardware die-casting factory is a method of casting liquid die forging. This process is completed on a special die casting die forging machine, but there is also a basic process flow. After the hardware die-casting factory has completed the fabrication, it is necessary to inspect and accept the hardware die-casting factory, and the inspection and acceptance shall be carried out under the available environmental conditions. Now Shuangcheng Hardware Die Casting Factory will give you a detailed introduction to what environment can be inspected p>
1、 Lighting environment
1. Light source. On the north side of thehardware die-casting factory, the inspection is carried out at about 8:00 a.m. to 10:30 a.m. and between 3:00 p.m. and 5:00 p.m. under the natural light during this period. If there is no natural light, you can also choose fluorescent lamps, pure fluorescent lamps and fluorescent lamps plus incandescent lamps p>
2. Illumination. The balance degree is the balance of the lighting on the inspection table, which can be calculated with a very small value or a very large value p>
2、 Observe the outdoor conditions.The hardware die casting factorywants to tell you about the occasions when the size of a point cannot be confirmed with a cover plate under some conditions p>
1. When the light is perpendicular to the desktop, we can observe it at an angle of 45 degrees p>
2. When the light is 45 degrees to the desktop, observe it at 90 degrees p>
These are the requirements for the inspection of the appearance and environment of thehardware die casting factory. After the manufacturing of the hardware die castings is completed, we can use the above methods to inspect. I hope it can help you p>
Related News
undefined